ELV systems that work together, tested and documented before handover
You need the cameras, access control, screens, and alarms to work as one system on the day you open, not as five contracts that first meet at commissioning. Your ELV systems are the extra low voltage networks that run a building. They cover security and surveillance, display and communication, scanning and screening, specialized systems, and environmental monitoring, all under one point of responsibility. You get every device tested to IEC 62676 and IEC 60839-11 before handover. You also get the as-built drawings, device schedules, and test reports you need to run and expand the system yourself.
One contract, not five installers who meet at commissioning
Split your ELV systems across five installers and the gaps between them become your problem on handover day. The camera vendor assumes the access-control vendor wired the door release. Neither one tests it. You find out during the fire inspection, with the opening date already booked. We hold the whole ELV scope, one number to call, one team that owns the result from design to certified handover.
Five systems, delivered as one scope
Most buildings buy these five separately and hope they meet. We design, install, test, and document them together, so they behave as a single system from day one.
Security solutions
IP CCTV, access control, intruder detection, and video intercom, with camera positions set from a site survey and storage sized for your retention period. Every device is tested to IEC 62676 and IEC 60839-11 before handover.
Five phases, one continuous thread
The same team carries the work from first survey to signed-off documentation. Nothing is handed between installers mid-project, so nothing falls through the gap.
Survey
We walk the site, confirm camera positions, door hardware, and containment routes, and capture existing conditions before any design work begins.
Design
One coordinated drawing set, with camera positions, door hardware, and containment on the same plan, and the interfaces resolved before installation starts.
Install
One crew, sequenced trades, containment first. No installer waits on another, and there is no rework when the camera run and the access-control cabling collide.
Test
Every device is commissioned and every integration is proven on site, including the fire-alarm door release, before handover.
Document
As-built drawings, device schedules, and full test reports, handed over so you can run and expand the system yourself.
Tested before handover. Documented so you can run it.
Commissioning is where most ELV projects quietly hand you a system nobody fully understands. We commission every device to standard, prove the integrations, and give you the paperwork to operate and expand the system without calling us back.
Start with an assessment, not a quote
Tell us what you are building. We will walk the site, scope the five systems together, and tell you plainly whether we are the right fit. If a single local installer would serve you better, we will say so.